Hi,
Cloning on an SSD/NVMe drive works without issue - cloning even relatively small sites (<5GB) sends CPU load through the roof. Looking at the process, it runs fileTransfer as so:
fileTransfer -run-type client -transfer-type std-pipes -target-path /var/www/vhosts/xxxx -writers-count 8 -queue-length 10 -routines-count 4 -tcp-host 127.0.0.1 -tcp-port 8082
Is there any way to adjust the bolded parameters ? If not I have to see about running a cron every minute that does a...
Read more
Cloning on an SSD/NVMe drive works without issue - cloning even relatively small sites (<5GB) sends CPU load through the roof. Looking at the process, it runs fileTransfer as so:
fileTransfer -run-type client -transfer-type std-pipes -target-path /var/www/vhosts/xxxx -writers-count 8 -queue-length 10 -routines-count 4 -tcp-host 127.0.0.1 -tcp-port 8082
Is there any way to adjust the bolded parameters ? If not I have to see about running a cron every minute that does a...
Read more